Ender 3 Printer Upgrade Kit
Tax included.
3D Printer Parts 3d Upgrade Kits For BL Touch Auto Bed Leveling Sensor Nozzle 0.2 0.3 0.4 0.5 0.6mm 1.75mm PTFE Tube For Ender 3
Description:
Introduction for Touch:1. For BLTouch is a type of semiconductor hall sensor and is an electronic component for 3D Printers.
2. For BL Touch is an auto-leveling sensor for 3D printers that can precisely measure the tilt of the bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
3. For BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensors. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release and touch switch mode, blue LED for servo signal indicating, and Z-probe(Zmin) Testing.
Features:
1. The main functions and controls of for BLTouch are the same as the usual auto bed leveling sensor, which consists of an RC servo and microswitch. Thus, for BLTouch can be applied on almost every board.
2. Self-test: The push pin operates two times in a test when the power is on.
3. Alarm: The LED light blinks if a problem was found on a self-test or during operation
4. Wiring Defect Indicator: Blue and Red LED for indicating wiring defects.
5. Easy to Use: This auto bed leveling sensor makes it easier to level the hotbed, which can precisely measure the tilt of the Bed surface. Bed leveling is not a problem anymore.
6. Intelligence Self - check and Alarm: The function of auto leveling is adopted to make it easier to use and to increase the success rate of shaping.
Packing List:
3D Touch Sensor*1
SD Card Converter*1(for Ender-3 V4.2.7 Version Mute Motherboard)
Connecting Line*1
Bracket*1
Cable Tie*2
Wrench*1
Screw*4
Original 1.75mm Blue PTFE Tube 1M*1
Large Pneumatic Connector*1
Small Pneumatic Connector*1
MK9 Brass Nozzle 0.2mm*1
MK9 Brass Nozzle 0.3mm*1
MK9 Brass Nozzle 0.4mm*1
MK9 Brass Nozzle 0.5mm*1
MK9 Brass Nozzle 0.6mm*1
Note:
1. Some 3D printer motherboards have insufficient 5V power supply and may require an external 5V power supply, which shows that the probe is difficult to push out, or the logic circuit protection main control restarts during operation. If encountered, it is generally recommended to use a DC-DC step-down module to take power from the main power supply.
2. +5V and GND should not be connected reversely, it may be burnt if connected reversely for a long time.
3. Please try to keep away from strong magnets, motors, fans, and other magnetic components.
4. Accidentally hitting the probe plastic rod may damage or affect the detection accuracy.
5. Adjusting or reassembling the set screw of the probe requires thread glue.
6. Please avoid deformation of the shell when installing the probe.
7. Pulling the aluminum rod hard will damage or affect the detection accuracy.